Cisco 3560 IOS problem

I have a WS-C3560X-24T-L   switch and I am getting the following error.

Base ethernet MAC Address: 00:1f:c9:96:60:80

Xmodem file system is available.

The password-recovery mechanism is enabled.

Initializing Flash...

flashfs[0]: 452 files, 6 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 15998976

flashfs[0]: Bytes used: 2176512

flashfs[0]: Bytes available: 13822464

flashfs[0]: flashfs fsck took 8 seconds.

.done Initializing Flash...

Boot Sector Filesystem (bs) installed, fsid: 3

done.

Loading "flash:c3560-ipbase-mz.122-35.SE5/c3560-ipbasemz.122-35.SE5.bin"...flash:c3560-ipbase-mz.12

2-35.SE5/c3560-ipbase-mz.122-35.SE5.bin: no such file or directory

Error loading "flash:c3560-ipbase-mz.122-35.SE5/c3560-ipbase-mz.122-35.SE5.bin"

Interrupt within 5 seconds to abort boot process.

Boot process failed...

The system is unable to boot automatically. The BOOT

environment variable needs to be set to a bootable

image.

Things which i have already tried:

switch:boot

Loading "flash:c3560-ipbase-mz.122-35.SE5/c3560-ipbase-mz.122-35.SE5.bin"...flas

h:c3560-ipbase-mz.122-35.SE5/c3560-ipbase-mz.122-35.SE5.bin: no such file or dir

ectory

Error loading "flash:c3560-ipbase-mz.122-35.SE5/c3560-ipbase-mz.122-35.SE5.bin"

Interrupt within 5 seconds to abort boot process.

When i issue Dir i got the following msg:

List of filesystems currently registered:

flash[0]: (read-write)

xmodem[1]: (read-only)

null[2]: (read-write)

bs[3]: (read-only)

Also Tried dir flash

unable to stat flash/: no such device

I also have ios of that switch and when i am trying to push through X modem i got below msg:

Unknown cmd: Š **B0**B000000000022d

switch: Š*00000002d

Unknown cmd: Š*00000002d

switch: Š**B000000000022d

Unknown cmd: Š**B000000000022d

switch: Š**B000000000022d

Unknown cmd: Š**B000000000022d

switch: Š**B000000

1) flash_init

2) load_helper

Next you need to change the baud rate on the switch, otherwise it will take about 2 hours to transfer the IOS via xmodem.

3) set BAUD 115200

After you issue the baud rate command on the switch make sure you also change it in Hyperterminal or whatever software terminal emulation software you use. Otherwise you won't be able to communicate to the switch.

4) copy xmodem:"image_filename.bin" flash:"image_filename.bin"

5) In Hyperterminal select "Transfer" and select "send file". Change the protocol to xmodem. Next select browse and navigate to where you have stored the IOS that you would like to transfer to the WS-C3560X-24T-S   switch. Click send.